GeeeTech A10 v4 Board 3D Touch Questions??

Post Reply
KellanCarson
Posts: 1
Joined: Wed Nov 10, 2021 7:02 pm

GeeeTech A10 v4 Board 3D Touch Questions??

Post by KellanCarson » Wed Nov 10, 2021 7:04 pm

Hello everyone,

I have a GeeeTech A10 with the V4 2560 board. It's a full width electronics setup, unlike the older versions. This model also comes with a metal L bracket for the 3D Touch. The issue is there is NO information anywhere about the offsets of this bracket, nor are there any firmware available for the V4 board and 3D touch pre-compiled I did make this work already with the latest 2.0 marlin; but I was curious if myappvalley tutuapp tweakbox
measurements are correct for the probe offset. Anyone else got this board and measured it? -47, -9 is what I measured.
Last edited by KellanCarson on Thu Nov 11, 2021 11:24 pm, edited 1 time in total.

fila1968
Posts: 1
Joined: Thu Sep 23, 2021 12:36 pm

Re: GeeeTech A10 v4 Board 3D Touch Questions??

Post by fila1968 » Thu Nov 11, 2021 2:55 am

hi
i got the same setup
and i am looking for marlin 2.0
can you share your firmware

hz_scotty
Posts: 3
Joined: Fri Nov 26, 2021 7:28 pm

Re: GeeeTech A10 v4 Board 3D Touch Questions??

Post by hz_scotty » Sun Nov 28, 2021 7:54 pm

Hello!
I bought a Geeetech A10 in July 2020, my board version is GT2560 v4.0.
The firmware is v2.0, the hardware is v5.60. Marlin v1.1.8 from 2017-12-25.
Now I have bought the Geeetech 3Dtouch sensor and installed it.
Is there a special 3Dtouch version for the board (v4.0) and the printer?
I have now downloaded the version A10_G05_V11.8_2-3DTOUCH.HEX from your
website and flashed it.

The printer now reports as GT2560 v3.x. :o

Is that correct?
Please answer,
thank you

Best regards
hz_scotty

Post Reply