A10 error in Y-axis

Post Reply
Linakesh
Posts: 9
Joined: Tue Jun 15, 2021 6:24 am

A10 error in Y-axis

Post by Linakesh » Mon Sep 27, 2021 7:21 pm

Hello everyone,,,
I bought this printer last year and now i figured out that the prints are "out of square". I don't know how to explain the issue properly but when the printer draw in the Y-axis it doesn't make the line in the required angle. Also, the slicer doesn't match the center of the bed with the printer. I use Repetier but i tried with Slic3r and Ultimaker Cura with the same issues.
The only modification that I made in the printer was low 1mm the Z endstop because I couldn't calibrate the bed properly.
anyone know what problem can make this issue?
https://showbox.bio/ https://tutuapp.uno/
Regards!!

expresspanda
Posts: 1
Joined: Thu Oct 07, 2021 3:06 pm

Re: A10 error in Y-axis

Post by expresspanda » Thu Oct 07, 2021 3:07 pm

Panda Express has a tremendous client base. It is famous for its pandaexpress/feedback amicable staffs, new and scrumptious Chinese food. In any case, at whatever point you run over a disillusioning survey about Panda Express, they answer to the individual, saying 'sorry' and trusting a similar mix-up won't occur once more.

Post Reply