a10m firmware update problem. Hot-end will not heat

Post Reply
Scott Forsyth
Posts: 2
Joined: Mon Sep 20, 2021 1:04 am

a10m firmware update problem. Hot-end will not heat

Post by Scott Forsyth » Mon Sep 20, 2021 1:36 am

Hi,

I just installed this firmware update for my A10m as from the geeetech page :

https://www.geeetech.com/download.html?download_id=31

A10M_TITANS_HW4.1B_FW2.3_20201021-Beta.hex

The hot-end will not heat up. The bed does but then heating fails.

Is there a fix for this?

I am also looking for a hex firmware version that I can roll back to.

As you can see from the upside down photos, the bed heated to 65C. Also, the temp of the hot-end is showing as -14. Weird.
Any help appreciated.

TIA,
Scott
20210919_121609.jpg
20210919_121609.jpg (351.55 KiB) Viewed 1025 times
20210919_121620.jpg
20210919_121620.jpg (357.74 KiB) Viewed 1025 times
Last edited by Scott Forsyth on Mon Sep 20, 2021 3:22 am, edited 3 times in total.

Scott Forsyth
Posts: 2
Joined: Mon Sep 20, 2021 1:04 am

deleted

Post by Scott Forsyth » Mon Sep 20, 2021 2:20 am

deleted post

Post Reply