geetech a10t

Moderator: vert

Post Reply
linsChaho
Posts: 2
Joined: Tue Aug 17, 2021 6:50 pm

geetech a10t

Post by linsChaho » Tue Aug 17, 2021 7:39 pm

so I have a geeetech a10 t same as the a10 just more colours

I just put a BL touch on it and im getting it ready to print.

BUT two issues one the z axis stop switch is always lighted now but doesn't seem to work

and two once i set it to auto home it does zx and y axis fine but once it goes to z it hits the heated bed and begins to grind.

Any ideas how whats going on ..thanks..Tweakbox Appvalley https://vlc.onl
Last edited by linsChaho on Sun Aug 22, 2021 7:28 pm, edited 1 time in total.

User avatar
Admin
Posts: 453
Joined: Wed Nov 30, 2011 9:49 am

Re: geetech a10t

Post by Admin » Wed Aug 18, 2021 5:03 pm

Hello, it may be a wiring error. Please pay attention to the wiring of 3dtouch, and whether the 3pin and 2pin pins are correctly connected in place.
You can refer to the following video to install:
https://www.youtube.com/watch?v=IaHzsd4DgeU

Post Reply