SKR V1.3 on the A10 - Any pointers?

guptashivamm1
Posts: 1
Joined: Tue Jul 27, 2021 12:09 am

Re: SKR V1.3 on the A10 - Any pointers?

Post by guptashivamm1 » Tue Jul 27, 2021 12:30 am

Hey hello, thanks for the tip.

nukapop92
Posts: 1
Joined: Sun Nov 07, 2021 5:09 pm

Re: SKR V1.3 on the A10 - Any pointers?

Post by nukapop92 » Wed Dec 08, 2021 6:56 pm

BigTreeTech's Marlin repo defaults to explicitly setting spreadcycle homing and provides zero documentation about it which cost me almost a week of my limited available time. get-vidmateapp.com
get-mobdroapk.com
Last edited by nukapop92 on Wed Dec 22, 2021 6:12 pm, edited 1 time in total.

hugoxavier683
Posts: 1
Joined: Wed Dec 15, 2021 1:59 am

Re: SKR V1.3 on the A10 - Any pointers?

Post by hugoxavier683 » Wed Dec 15, 2021 2:04 am

I did something dumb, broke my thermistor loose trying to change the nozzle and apparently fried.

The controller such that I didn't kill the fuses, just any ability to read a temperature correctly.

I have an SKR 1.3 on the way, arriving Monday since it was actually cheaper to upgrade than to replace.

I'll probably step up to the TMC2130's at some later date but for now it's just a straight-up replacement of the GT2560 v3 I'm after.

Has anybody done this upgrade successfully? Any gotchas for which I need to be on the lookout.

I'm okay with microelectronics, just apparently ham-handed with a wrench

lewiscamron70
Posts: 1
Joined: Fri Jan 07, 2022 4:29 am

Re: SKR V1.3 on the A10 - Any pointers?

Post by lewiscamron70 » Fri Jan 07, 2022 4:33 am

I did something dumb, broke my thermistor loose trying to change the nozzle and apparently fried the controller such that I didn't kill the fuses, just any ability to read a temperature correctly.

I have an SKR 1.3 on the way, arriving Monday since it was actually cheaper to upgrade than to replace.
I'll probably step up to the TMC2130's at some later date but for now it's just a straight-up replacement of the GT2560 v3 I'm after.

Has anybody done this upgrade successfully?
Any gotchas for which I need to be on the lookout?
I'm okay with microelectronics.
just apparently ham-handed with a wrench.

Post Reply