Z axis too high with 3D Touch!!

Post Reply
tanishbel87
Posts: 8
Joined: Sun Oct 25, 2020 1:15 pm

Z axis too high with 3D Touch!!

Post by tanishbel87 » Thu Dec 09, 2021 4:23 am

Hej,

I just installed the 3D Touch on My I3 Pro W with selve printed mount from instruction, installed the Firmware from this Forum for this and added Code G29 in Cura for My prints. I can see that the Printer is doing the autolevelling, but the result in Z axis is just a few Millimeter too high, therefore the nozzle prints 'in the air' above the bed. What do I Need to adjust here? There is no way to put the 3D Touch sensor higher with this mount.

Thank you in advance for some advice.10.0.0.0.1 192.168.1.254

Post Reply