Geeetech i3 Pro W initial set up issues

Post Reply
abhimanyu
Posts: 1
Joined: Thu Nov 18, 2021 10:29 pm

Geeetech i3 Pro W initial set up issues

Post by abhimanyu » Thu Nov 18, 2021 10:54 pm

Hi all,

I'm having a lot of trouble with my initial configuration. I added the printer as a custom printer in Cura, and entered the dimensions (200x200x180).

The X and Y homing is working fine, however the Z homing is not.I disabled the stepper motors, and then lowered the extruder, set the bed height, then when I pressed "up" in Cura, it went up, but it never went back down. When I click the 'Home' button for Z, it just goes and crashes into the top.Anyhelp would be amazing right now.appvalley tutuapp tweakbox
Last edited by abhimanyu on Wed Nov 24, 2021 9:43 pm, edited 1 time in total.

User avatar
Admin
Posts: 486
Joined: Wed Nov 30, 2011 9:49 am

Re: Geeetech i3 Pro W initial set up issues

Post by Admin » Fri Nov 19, 2021 2:00 pm

You maybe need to check whether you install the Z end stop correctly, and check whether the endstop works. Better swap one.

Post Reply