GTBOX con Board V1

Post Reply
Eclipses
Posts: 3
Joined: Mon Apr 08, 2019 2:22 am

GTBOX con Board V1

Post by Eclipses » Mon Apr 08, 2019 4:28 am

Hi,

I've completed the installation of the Geeetech Prusa I3 A pro (a bealieve the A means Aluminium). It has a board called GTBOX con Board v1. I'm facing difficult to make it working because the Z axis move down slowly but it does not move up. I read that the issue could be electrical but right now I do not know how to proceed. Should I upgrade the drivers? if yes, which is the correct one for my board, I did not find this info in the link with list of drivers.

Please help me to figure out how to make it working. After almost 1 day spent to assemble I was expecting at least to be able to run my first print :-(

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: GTBOX con Board V1

Post by William » Mon Apr 08, 2019 6:22 pm

I suggest you refer to the FAQ of it at first:
"Geeetech I3/DIY Printer Series" section pin-up post.
https://www.geeetech.com/forum/viewtopi ... 09&t=61933
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply