Moving Z problem

Post Reply
Hamed
Posts: 2
Joined: Thu Apr 19, 2018 5:28 am

Moving Z problem

Post by Hamed » Tue Apr 24, 2018 10:33 pm

I just assembled my printer but the z axis move very badly I mean

the torque of motors is very very low and I had to almost open all the screw of the T8 lead screw nut that motors can move the z axis but I know it's not good solution and will reduce the quality of the print so what is the best solution ? is that problem because of the long and slim wires from the drivers to the motors ?

thank you.

User avatar
_kaktus_
Site Admin
Posts: 1260
Joined: Fri Dec 15, 2017 10:06 pm
Location: PL
Contact:

Re: Moving Z problem

Post by _kaktus_ » Thu Apr 26, 2018 12:26 am

A similar problem and ways to solve it are often discussed in the forum.
Just read ...

Hamed
Posts: 2
Joined: Thu Apr 19, 2018 5:28 am

Re: Moving Z problem

Post by Hamed » Sun Apr 29, 2018 9:01 pm

it solved by increasing output current of Z stepper motors driver.

Eclipses
Posts: 3
Joined: Mon Apr 08, 2019 2:22 am

Re: Moving Z problem

Post by Eclipses » Mon Apr 08, 2019 2:32 am

Hi, I have exactly same problem could you please help me to understand how to increase the current for the motors? In my printer I did not find any screw for this. Thanks

User avatar
_kaktus_
Site Admin
Posts: 1260
Joined: Fri Dec 15, 2017 10:06 pm
Location: PL
Contact:

Re: Moving Z problem

Post by _kaktus_ » Mon Apr 08, 2019 12:35 pm

Hi.
:mrgreen:

So you need to read the description of the stepstick module.
;)

Maybe it?
:P
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.

Gause47
Posts: 1
Joined: Mon Nov 15, 2021 1:22 pm

Re: Moving Z problem

Post by Gause47 » Mon Nov 15, 2021 1:26 pm

Hamed wrote:
Tue Apr 24, 2018 10:33 pm
I just assembled my printer but the z axis move very badly I mean

the torque of motors is very very low and I had to almost open all the screw of the T8 lead screw nut that motors can move the z axis but I know it's not good solution and will reduce the quality of the print so what is the best solution ? is that problem because of the long and slim wires from the drivers to the motors ? skylightpaycard

thank you.
Z Moves and Mega Evos only work in Ultraspace, there is a config option that ask which World should use old Gen mechanics and youd need to add in 0, for overworld, so that it would work.

Post Reply