Z axis limited to 100

Post Reply
gabber
Posts: 2
Joined: Wed Dec 25, 2019 9:20 pm

Z axis limited to 100

Post by gabber » Wed Dec 25, 2019 10:47 pm

Hi Everyone,
in my Geetech I3 alu, i never printed object taller than 100mm

When i try this morning, i see a limit a 100mm.

when i try to move more than 100 directly on" move panel" in printer, i can't go .

anyone now what setting i need to move to push the limit to 180?

It's a soft limit because when i change the step ratio, i can go to 180mm physicaly but under 100 in command.

gabber
Posts: 2
Joined: Wed Dec 25, 2019 9:20 pm

Re: Z axis limited to 100

Post by gabber » Thu Dec 26, 2019 9:34 am

ok, i fixed the problem.

with :
  • arduino 1.01
  • firmware:PI3_Sanguino
thanks for the fast reply

Post Reply