X-axis issues - loosing home ofset

Post Reply
dahaus
Posts: 3
Joined: Tue Mar 17, 2020 6:53 pm

X-axis issues - loosing home ofset

Post by dahaus » Tue Mar 17, 2020 7:00 pm

I had upgraded the firmware, until then I have issues start printing. When I try home ofset it always move right, like it always move home ofset. I'm uploading video of behaving.

I can't solve this problem for couple of months, I stop printing after this failure. :cry:

https://youtu.be/EkkTBx8Jqzo

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: X-axis issues - loosing home ofset

Post by William » Tue Mar 17, 2020 7:05 pm

Hi,If the extruder runs in the opposite direction than you expected,
You can view the motor settings in the firmware,
If it is changed to false,
false to true,

If the motor only runs in one direction,
You can enter m119 in the manual control of the repetier host,
Check the limit switch.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

dahaus
Posts: 3
Joined: Tue Mar 17, 2020 6:53 pm

Re: X-axis issues - loosing home ofset

Post by dahaus » Tue Mar 17, 2020 8:17 pm

Thanks, ive tried, but the problem still persist. Its strange when I try to go home on x axis, it moves little bit and return to this new point, even by the printing, so the print is shifted after while.

In firmware I tried also reverse the x axis, it worked in opposite way, but with the same problem. The home axis moved every time. Like on the video.

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: X-axis issues - loosing home ofset

Post by William » Wed Mar 18, 2020 10:39 am

Hi,Can you do Auto Home.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

dahaus
Posts: 3
Joined: Tue Mar 17, 2020 6:53 pm

Re: X-axis issues - loosing home ofset

Post by dahaus » Wed Mar 18, 2020 4:36 pm

Yes, and it moves after the auto home. Its on the video, every time when I try do Autohome, it moves to right. I also change end switch, motors and nothing.

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: X-axis issues - loosing home ofset

Post by William » Wed Mar 18, 2020 4:49 pm

Hi,you can check if your motherboard wiring is correct,
Is it possible to flash the firmware back to the original version,
Check it out.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply