Bad part or am I missing something??

Post Reply
Minato009
Posts: 2
Joined: Fri Jun 11, 2021 6:31 am

Bad part or am I missing something??

Post by Minato009 » Fri Jun 11, 2021 6:38 am

I am part way through assembly when I need to install the two t-shaped linear bearings. One of the has the holes on the bottom correctly countersunk to allow an M3-6mm screw to fit flush when tightened. The other had the countersunk holes drilled next to the post rather than on the bottom.
20190510_004203.jpg https://100001.onl/ https://1921681254.mx/
20190510_004203.jpg (671.09 KiB) Viewed 2654 times

I have checked the instructions carefully but there doesn't appear to be a way to affix the latter and I am begining to think I have a incorrectly milled part. Has anybody else encountered this and am I misunderstanding something or do I have a part that needs replacing?

dejaolsone
Posts: 2
Joined: Mon Nov 16, 2020 4:51 pm

Re: Bad part or am I missing something??

Post by dejaolsone » Mon Jun 14, 2021 10:16 am

Answer hundreds of intellectual questions
the impossible quiz

ArcherWentworth
Posts: 1
Joined: Fri Jun 11, 2021 2:55 pm

Re: Bad part or am I missing something??

Post by ArcherWentworth » Mon Jun 14, 2021 6:36 pm

There is no examination of the keto items. These items are protected to utilize and have the best to manage them. These are protected to utilize and help you stay fit, sound and, glad Moreover they are also providing dissertation help services to manage your writing tasks. There us no destructive impacts of these items. Visit their authority site to remain refreshed.

Post Reply