Geetech A30 break down looking for some help

Post Reply
BlackBlrd
Posts: 2
Joined: Fri Nov 20, 2020 7:24 am

Geetech A30 break down looking for some help

Post by BlackBlrd » Fri Nov 20, 2020 7:41 am

so i went to start a print and the touch stopped working, i could get it to change the screen with error codes but still couldn't use the touch screen
i did some research and was pretty sure it was the drivers so i installed new drivers, then i turned it on to a blank screen (no on pixels) but it still beeped when i turned it on, so i changed the stepper drivers (thinking i mixed them up) then i put one in backwards by mistake and turned it on and wrecked that driver and now it doesn't even beep when i turn it on. (i was gonna buy a new power supply touch screen thing but i would like to know if this is salvageable?)

nanali
Posts: 4
Joined: Tue Jun 29, 2021 3:15 am
Contact:

Re: Geetech A30 break down looking for some help

Post by nanali » Tue Dec 14, 2021 4:48 am

https://www.academicsaviour.com/jia-na-da-cs-dai-xie
cs代写, 加拿大计算机代写, cs 代写
cs writing, Canadian computer writing, cs writing

Post Reply