Printer Setting for EasyPrint3D
Posted: Sun Aug 01, 2021 1:34 am
Hello there,
on the SD Card are two GCode Files (cat and dog), which were included with the E180 printer.
The printing out this 2 files has very good quality.
Can you provide the printer setting as e.g. *.ini-file for the slicer, which were used for creating this 2 gcode-files (cat and dog)?
In EasyPrint3D (Ver 1.1.7) are 3 setting tabs, where I can change many settings. There is no documentation of right settings, which the E180 can handle.
Regards.10.0.0.0.1 192.168.1.254
on the SD Card are two GCode Files (cat and dog), which were included with the E180 printer.
The printing out this 2 files has very good quality.
Can you provide the printer setting as e.g. *.ini-file for the slicer, which were used for creating this 2 gcode-files (cat and dog)?
In EasyPrint3D (Ver 1.1.7) are 3 setting tabs, where I can change many settings. There is no documentation of right settings, which the E180 can handle.
Regards.10.0.0.0.1 192.168.1.254