Geeetech

Hello there,

on the SD Card are two GCode Files (cat and dog), which were included with the E180 printer.
The printing out this 2 files has very good quality.

Can you provide the printer setting as e.g. *.ini-file for the slicer, which were used for creating this 2 gcode-files (cat and dog)?
In EasyPrint3D (Ver 1.1.7) are 3 setting tabs, where I can change many settings. There is no documentation of right settings, which the E180 can handle.

Regards.10.0.0.0.1 192.168.1.254

Hello, you can directly use Easyprint Lite Release, which has a matching E180 configuration file.

Glad to chat your blog, I seem to be forward to more reliable articles and I think we all wish to thank so many good articles, blog to share with us.
run 3