I bought a new E180 in 2020. After few printings, I got the message error:
"error nozzle 0-temp the heating element is out of order"
I exchanged the nozzle to a new one, but the error is the same. I upgraded the firmware as written somewhere in the forum and the error remains with an additional issue: each time that I switch on the printer, it gives a long beep (1-2 seconds) and reboots. Then I can go again to the control menu or start print, but before it stats, the error message of error nozzle appears again.
Since the new nozzle didn't solve the problem, I put again the old one. I looked to the board with 4 contacts with springs, which is very fragile. Even though, they were performing contact. Strangely, after re-assembling it, the printer started to work again, but with the temperature very unstable. After a couple of minutes of a test printing, the temperature stabilized. After one or two days without usage, I switched on the printer, and the error appeared again and now I cannot put it working with the old or new nozzle.
What is damaged here? Why the long beep? Anyone has suggestions?! Many thanks!
Error nozzle and long beep at the beginning
Re: Error nozzle and long beep at the beginning
I switched the nozzle to a new one. The measurement of the temperature seems ok, but it cannot heat. Any help?