Printer Setting for EasyPrint3D

Post Reply
Posts: 2
Joined: Wed Jul 28, 2021 10:29 am

Printer Setting for EasyPrint3D

Post by MoniBinis » Sun Aug 01, 2021 1:34 am

Hello there,

on the SD Card are two GCode Files (cat and dog), which were included with the E180 printer.
The printing out this 2 files has very good quality.

Can you provide the printer setting as e.g. *.ini-file for the slicer, which were used for creating this 2 gcode-files (cat and dog)?
In EasyPrint3D (Ver 1.1.7) are 3 setting tabs, where I can change many settings. There is no documentation of right settings, which the E180 can handle.

Last edited by MoniBinis on Wed Aug 04, 2021 9:14 pm, edited 1 time in total.

User avatar
Posts: 453
Joined: Wed Nov 30, 2011 9:49 am

Re: Printer Setting for EasyPrint3D

Post by Admin » Wed Aug 04, 2021 10:44 am

Hello, you can directly use Easyprint Lite Release, which has a matching E180 configuration file.

Post Reply