Nozzle Error 0 TEMP - Heatbed does not heat up

Post Reply
testoli
Posts: 2
Joined: Fri Mar 15, 2019 12:30 am

Nozzle Error 0 TEMP - Heatbed does not heat up

Post by testoli » Fri Mar 15, 2019 12:52 am

Hi,

I am totally lost.
My A30 is not working. My heatbed is not heating up. Ventilator is kickin up and the heatbed is starting to warmup veeeery slowly. At 24 Celcius a Popmessage is shown up "Nozzle Error 0- TEMP ....bla bla

I upgraded to the latest Firmware and I bought a new heatbed and Superplat as I thought it could be a broken wire, but with no luck.
The message is coming up every time and I am totally bothered.
1.jpg
1.jpg (234.89 KiB) Viewed 18835 times
3.jpg
3.jpg (176.14 KiB) Viewed 18835 times

Support! Please help to solve that issue.

Thanks a million.

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Nozzle Error 0 TEMP - Heatbed does not heat up

Post by William » Fri Mar 15, 2019 5:21 pm

This error info means the temp of the hotbed or the nozzle incorrect.
1.The error info from the hotbed(You need to check the LCD info at first)
If you found the temp of the hotbed is -14C then you should check the wires of the hotbed loose or disconnect.
You should replug it and check it with the multimeter.
2.The error info from the nozzle
The check steps are same as hotbed.
If you don't know how to do it,you can attach the photos of the hotbed/hotend wires of input.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

testoli
Posts: 2
Joined: Fri Mar 15, 2019 12:30 am

Re: Nozzle Error 0 TEMP - Heatbed does not heat up

Post by testoli » Sat Mar 16, 2019 5:57 pm

HI,

I now checked the connectors and cables. As the heatbed is brand new I assume that this is not the problem, BUT I took a photo from the connector.
IMG_20190316_104652.jpg
IMG_20190316_104652.jpg (250.81 KiB) Viewed 18790 times
There is one pin that does not seems to be ok.

Any chance to get this fixed? I tried sand the pin, but it is still not working.

Thanks in advance

Post Reply