Re: Firmware Fix by Tom Servo

Post Reply
Posts: 25
Joined: Wed May 03, 2017 11:58 pm

Re: Firmware Fix by Tom Servo

Post by Bama3d » Sat May 20, 2017 1:00 am

tomservo wrote:Nothing I can do will get this printed to even half the quality of any of my other printers. No matter what I replace, what code I change, this thing just plain-ol' STINKS! Build quality is... very poor. The best quality printed I've gotten from it are still unacceptable. Months of work, hundreds of extra dollars of parts and this thing is still worse than my $250 prusia i3 :( I wish I wish I wish I wish I could return it and get my money back.

Do not make the same mistake as me-- do NOT buy this printer!

Welcome to Geeetech, we are in the same boat just with different printers.

Posts: 7
Joined: Fri May 19, 2017 2:17 am

Re: Firmware Fix by Tom Servo

Post by JustSumGuy » Mon May 22, 2017 1:29 pm

ya I was given as in FREE an ME Creator..... and after a few weeks I know why.......

Aircraft Monkey
Posts: 12
Joined: Sat Jun 03, 2017 2:59 pm
Location: USA

Re: Firmware Fix by Tom Servo

Post by Aircraft Monkey » Sat Jun 03, 2017 3:08 pm

I'm sorry but i'm sure that there are ways to get better quality. I did with my other machine on things that no one else could. Don't give up. I know it takes a while to get settings just right. I use Autodesk software to do most of my printing and it has better builds than other cheap software. You might give it a try. Inventer pro is one.

Post Reply