3DTouch with Creality 4.2.7 motherboard

Post Reply
Khitomer
Posts: 1
Joined: Mon Jun 07, 2021 5:23 am

3DTouch with Creality 4.2.7 motherboard

Post by Khitomer » Mon Jun 07, 2021 10:12 pm

I recently upgraded my Ender 3 v1 with a Creality 4.2.7 motherboard which is an amazing upgrade. I decided to add a self levelling option and bought a 3DTouch sensor. However on connecting it up the sensor extends twice then stops and stays continuously red. I’ve read online this is a wiring issue. As the instructions for connecting the sensor to the board were very poor I suspect that there may be an issue with how I wired it up?

Anyone got any advice?

Post Reply