GT2560 rev A question.

Post Reply
esurplusplus
Posts: 1
Joined: Fri Jun 16, 2017 11:15 am

GT2560 rev A question.

Post by esurplusplus » Mon Jan 06, 2020 7:19 am

I have the pictured GT2560 Rev A board, and was wondering if anyone knows what the 2 pin header is for, as well as the 8 pads that look like a pin header would have been there? Interested in if the 8 pads are NOT connected to anything, so they could be used to solder pins, then jumper wires from unused I/O pins on the Mega 2560 to those pins.
Attachments
20200105_142358-1.jpg
20200105_142358-1.jpg (364 KiB) Viewed 13733 times

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: GT2560 rev A question.

Post by William » Mon Jan 06, 2020 10:37 am

:D Hi, 2pin is a switch on the jumper cap of the motor driver board,
8 holes are reserved for welding holes.
You can refer to the motherboard schematic diagram: https://www.geeetech.com/download.html?download_id=43
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply