3D touch/Pro W won't home

Post Reply
Kiamiya
Posts: 1
Joined: Fri Jul 06, 2018 4:12 am

3D touch/Pro W won't home

Post by Kiamiya » Thu Sep 13, 2018 1:18 am

Hello,
After weeks of search without any clue, I come here to ask for some help.

Here a link to the video of my issue (I made an emergency stop at the end)
https://youtu.be/1MyBdcKjtmc

I use this firmware
firmware.JPG
firmware.JPG (21.86 KiB) Viewed 17206 times
Also here my wiring
cable bn.JPG
cable bn.JPG (255.55 KiB) Viewed 17206 times
cable rom.JPG
cable rom.JPG (266.09 KiB) Viewed 17206 times
So, all is good with the selftest but, when I try to Home, the pin goes up and never do it's job.. :cry:

Any clue for me? :roll:
Thanks

TwiHul
Posts: 6
Joined: Sun Oct 27, 2019 4:21 pm

Re: 3D touch/Pro W won't home

Post by TwiHul » Thu Mar 19, 2020 6:26 pm

I never managed to get it working with Marlin 1. I used Marlin 2 and managed to figure it out from there. There’s an example config out there that uses the Z MAX pins instead of Z MIN but I had to change it to just use Z MIN to get it working.

Post Reply