infomats wrote:I have just bought and assembled the printer, but it is not printing properly, it prints but filament is not coming out properly and it becomes a mess , it is just melting the filament and just waisting it, pla help to make it print as i have cleaned the nozzel as well but no luck.
Old post I know but may help someone else....
I had this issue with the undamaged factory nozzle straight out of the box...
Take the factory nozzle off.
Throw it in the bin.
Buy a new 0.4mm one.
Even a cheap 99p ebay one is an upgrade and worked like a charm to get you started.
The original nozzle looked like it was made by a badly trained monkey!
The 0.35mm hole was only 0.2mm was drilled at an angle off centre and had swarf blocking it!