New A10 with mylar, what to do with the sticker

Post Reply
BucksDanny
Posts: 5
Joined: Tue Jan 14, 2020 2:40 pm

New A10 with mylar, what to do with the sticker

Post by BucksDanny » Tue Jan 21, 2020 4:26 pm

Hello, I just purchased my first Geeetech A10 printer. It is delivered with an aluminium hotbed and a mylar sticker.
1.jpg
Hotbed with blueish sticker and mylar sticker
1.jpg (157.13 KiB) Viewed 14289 times
Unfortunately there are no instructions how to install it. Just sticking it on seems pretty straightforward, but what do I need to do with the blueish sticker that is currently stuck on the hotbed? I suspect it to be a protective sticker for transportation but I am not 100% sure if I should remove it. :?
Somebody can help me out?

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: New A10 with mylar, what to do with the sticker

Post by William » Tue Jan 21, 2020 4:30 pm

:D Hi, You need to glue the mylar to the aluminum substrate,
Remove the protective film if it is on the aluminum substrate
Then stick the Mylar to the aluminum substrate.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply