Stepper moters spin in wrong direction?

Post Reply
Chakusin
Posts: 5
Joined: Wed Nov 20, 2019 3:51 pm

Stepper moters spin in wrong direction?

Post by Chakusin » Wed Jan 08, 2020 8:10 pm

Hello everyone,,
When I send a file to my printer, I press print, and the stepper moters go the oposite direction as where the endstops are.
(1) should I make a video because that was not very clear mobdro lucky patcher kodi
(2) If you understood it, is there a solution? :?:
Last edited by Chakusin on Sat Jan 11, 2020 3:15 pm, edited 1 time in total.

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Stepper moters spin in wrong direction?

Post by William » Thu Jan 09, 2020 9:05 am

:D Hi, If you mean that the motor is running in the opposite direction than expected,
You need to change the motor's running direction in the firmware.

For specific operations, you can refer to: viewtopic.php?f=17&t=17037
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

lyqyzyca
Posts: 1
Joined: Tue Oct 05, 2021 6:50 pm

Re: Stepper moters spin in wrong direction?

Post by lyqyzyca » Tue Oct 05, 2021 6:52 pm

Steeper motors have the ability to spin in the wrong direction and this is a question by the pst makers. The 3D software printer by the Gree technology has shared the answer and https://www.australian-writings.org/ follow up the post in the proper kind of the mode and stations.

nokycycos
Posts: 1
Joined: Wed Dec 15, 2021 1:23 pm

Re: Stepper moters spin in wrong direction?

Post by nokycycos » Wed Dec 15, 2021 1:24 pm

Question here is the stepper motors spin in the wrong direction with the 3 D printing software installation as well. The content is going to the dimension of the Phoenix iv therapy with the quality situation and the move of great dimensions for the year to understand.

Post Reply