Rostock 301

Post Reply
Percy
Posts: 33
Joined: Tue Dec 27, 2016 5:33 am

Rostock 301

Post by Percy » Sat Apr 15, 2017 3:48 am

Help I need to replace 2 Diagonal rods with bearing rod ends. There are six going down to the 3 in 1 hot end. I broke one trying to adjust it because it wasn't the same length as the others! They have been glued (Lock tight) so I broke it! They are not in the spares list so I cant just buy them! Can geeetech please help so that I can start using my 301 printer
Thanks in advance

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Rostock 301

Post by William » Mon Apr 17, 2017 9:52 am

Hi,you can contact your seller about it.Please provide some pictures or videos.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

keldahr
Posts: 3
Joined: Thu Mar 30, 2017 5:42 am

Re: Rostock 301

Post by keldahr » Tue May 02, 2017 10:52 am

Having trouble with extruder 0. Will not push filament. I see the motor trying to work, but acts like there is not enough power to move filament. I swapped extruder 0 with #2 (There are 3 obviously) and same thing. Is this a common issue? If so what is resolution? Do I need to unlug all the fans on the extruders to allow the board to give proper voltage to extruder 0?

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Rostock 301

Post by William » Tue May 02, 2017 3:11 pm

Hi,you can refer to the following post to increase the power to move filament:http://www.geeetech.com/forum/viewtopic ... 19&t=18650
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

keldahr
Posts: 3
Joined: Thu Mar 30, 2017 5:42 am

Re: Rostock 301

Post by keldahr » Fri May 12, 2017 1:10 am

Tension not the problem. With no filament loaded all it does in first position is make small movements back and forth. Link provided did not show how to increase voltage, just how to creat more tension. I have the latest Rostock 301 with the GTM32 pro + 6 A4988. Would I simply turn the screw on the A4988 driver clockwise to increase voltage? I do think that voltage is the issue.
Last edited by keldahr on Fri May 12, 2017 2:31 am, edited 2 times in total.

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Rostock 301

Post by William » Fri May 12, 2017 11:56 am

Yes,you can take a try.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply