Burn mark on GT 2560 Rev A+

Post Reply
Dthomson39
Posts: 2
Joined: Wed Jun 17, 2020 2:22 am

Burn mark on GT 2560 Rev A+

Post by Dthomson39 » Tue Aug 04, 2020 3:20 pm

Hi all,

My printer just stopped dead - none of the steppers will operate and this all happened at once for some reason. I had noticed a burn mark on the board a few weeks ago but the printer seemed fine so I am not sure the issue is connected. I have attached an image of the areas of the board affected but I have nothing connected to the pins next to the location of the burn so I have no idea what this is or why it happens - suggestions welcomed.
Attachments
Burnt Area.jpg
Burnt Area.jpg (424.65 KiB) Viewed 4488 times

Post Reply