new build and x axis problems
Posted: Mon Feb 27, 2017 4:39 am
Hi, Just finished building the Prusa i3 pro b printer, installed with the gt2560 rev a+ board.
i have checked all connections, so know its not a hardware problem. when i select home all axis return home ok, eccept the x-axis which
goes right instead of left and hits the end jamming the motor. I have seen quite a few other people with the same problem. but no proper
fix.
I have changed the " #define X_HOME_DIR 1" setting which stops the motor going right, but it still does not home. i have to manually
park it.
has anyone else had this issue and how did you fix it ?
any help gratefully appreciatted.
manny
i have checked all connections, so know its not a hardware problem. when i select home all axis return home ok, eccept the x-axis which
goes right instead of left and hits the end jamming the motor. I have seen quite a few other people with the same problem. but no proper
fix.
I have changed the " #define X_HOME_DIR 1" setting which stops the motor going right, but it still does not home. i have to manually
park it.
has anyone else had this issue and how did you fix it ?
any help gratefully appreciatted.
manny