Y movement changes during print

Post Reply
Graham
Posts: 0
Joined: Mon Feb 05, 2018 11:13 pm

Y movement changes during print

Post by Graham » Mon Feb 05, 2018 11:21 pm

My prints start good but after a short time the Y motor clicks and misses steps meaning that the y direction is about halved. The stepper functions well at the start but after about a minute jumps into this click and missing step routine. Can any one help?
Top
User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Y movement changes during print

Post by William » Tue Feb 06, 2018 9:41 am

I think you can swap the Y axis and X axis motor driver board A4988
Then you can test it.You will find the issue is A4988 or not
-Keep your mind and try to test it. :)
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Top
User avatar
_kaktus_
Site Admin
Posts: 1260
Joined: Fri Dec 15, 2017 10:06 pm
Location: PL
Contact:
Contact _kaktus_

Re: Y movement changes during print

Post by _kaktus_ » Tue Feb 06, 2018 12:04 pm

You can increase the controller current.
Top
Post Reply

Return to “Stepper Motor”