Hello
I have recently received this module and was trying to upload some voice commands using AccesPort software
Connected via the ttl card, set to "common mode", message received, all good.
Then when I tried to start the upload procedure (AA 11), I have send the code but received no answer (Start, Again, etc), nothing.
Also the red led keeps blinking all the time since. I wasn't able to receive any answer since, it looks like the board it's stuck in that mode and it will not accept any input any-more.
I have tried 2 more devices (another TTL board and one Arduino Nano) and also another software (Hterm). Same, no reply from the voice board, the red led keeps fast blinking all the time.
Anyone has any idea if I can somehow hard reset the board so it will come out out of that mode? Or any other solution beside bin it?
Is any Geeetech employee actually reading this and can help or guidew me to the right tech department?
I have tried also to message for help Emma on Facebook but she didn't bother to reply, I guess if it's not a 3D printer it's not important
Please let me know if you have any idea.
TY
Geetech Voice Module faulty / errors
Re: Geetech Voice Module faulty / errors
Hi, If you refer to this situation you can contact your sales to replace it.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!