Newbie asks for help !!!

Post Reply
Der Wäller
Posts: 2
Joined: Tue Jul 13, 2021 4:33 pm

Newbie asks for help !!!

Post by Der Wäller » Tue Jul 13, 2021 5:01 pm

Hello colleagues, I am new to 3d printing and I need your help.
My A30 Pro prints the figure supplied by Geeetech in super quality!
When I slice other models with Cura, threads and stripes can be found on the outer contour. Is too much filament inserted? Where in Cura can I regulate it?
Thank you in advance!
MFG from Germany

User avatar
Admin
Posts: 486
Joined: Wed Nov 30, 2011 9:49 am

Re: Newbie asks for help !!!

Post by Admin » Fri Jul 16, 2021 10:12 am

Hello, this is generally due to the effect of temperature or the setting of the layer height is too high. It is recommended that the layer height is 0.2mm. If you want a more exquisite model, 0.1 is also possible, but the printing time will also be doubled.
Attachments
Cura4.9_A30T_0.2_PLA.rar
(1.11 KiB) Downloaded 319 times

Der Wäller
Posts: 2
Joined: Tue Jul 13, 2021 4:33 pm

Re: Newbie asks for help !!!

Post by Der Wäller » Mon Jul 19, 2021 9:31 pm

Hello admin, thank you very much for your help! The printouts are now very good after I added the Cura profile of the A10T in Cura. Then I made a few settings in this profile and now my A30 Pro prints as I wanted it to.
All the best and good luck!
Hermann :idea:

Post Reply