I have issues while using 3 extruders on A20T. I set printer exactly like was described here in download section with importing printer profile but still I have the same problems as before. Main problem is one heater and 3 sources of filament. I found on web "Extruders share heater" paramater for CURA, I modified json configure files but with no result - Ultimaker deleted that function because of damaging some printers. I set for PLA on all "extruders" temperature to 215 and when I use just first one than all looks OK. While using second or third source of filament then main heater is set to 0 during CURA 3-extruders logic. I am using the newest CURA and I have no idea how to fix it up and start to work normally. The problem gcode generaterd by CURA is (using only extruder no 3):
Code: Select all
1 ;FLAVOR:Marlin
2 ;TIME:662
3 ;Filament used: 0.146773m, 0m, 0.254283m
4 ;Layer height: 0.1
5 ;MINX:55.257
6 ;MINY:119.1
7 ;MINZ:0.3
8 ;MAXX:249.214
9 ;MAXY:247.213
10 ;MAXZ:7
11 ;Generated with Cura_SteamEngine 4.11.0
12 T0
13 M140 S65
14 M105
15 M190 S65
16 M104 S215
17 M104 T2 S175
18 M105
19 M109 S215
20 M105
21 M109 T2 S175
22 M82 ;absolute extrusion mode
23 G28
24 G1 Z15 F300
25 M107
26 G90
27 M82
28 M104 S215
29 M140 S55
30 G92 E0
31 M109 S215
32 M107
33 M163 S0 P0.33
34 M163 S1 P0.33
35 M163 S2 P0.34
36 M164 S4
...
2044 M104 T2 S215
...
2408 M104 S200
...
//And finaly after first layer
2802 M109 S215
2803 M104 T0 S0
Attachment includes temperature set for extruder no 3.
Thanks for helping me with that.