BL Touch Install

Post Reply
Neil PC
Posts: 6
Joined: Wed Feb 10, 2021 8:19 pm

BL Touch Install

Post by Neil PC » Thu Mar 04, 2021 1:54 am

After spending days trying to install the firmware 2.3 using Rapier Host and it failing every time I saw a post on here suggesting Cura.
I tried that and it installed first time.

I then experienced difficulties with setting up the Z offset and the probe failing and entering alarm mode, this could happen after two operations or twelve operations, there was no logic to it.. After contacting my supplier they suggested adjusting the screw on the top.

I turned about half turn clockwise and it seems to work fine now, I left it on test mode for 15 minutes without failing.

I set Z offset by lowering Z until the extended probe just touched the bed and secured it, then measured the gap to extruder with a gap setting tool and worked out the offset.

I hope this helps someone else.

Neil
Attachments
@27PQQ%4D{2{ULP[)]K)Q00.png
@27PQQ%4D{2{ULP[)]K)Q00.png (584.99 KiB) Viewed 2521 times
Neil

Post Reply