Just purchase my machine

Post Reply
Spideryon
Posts: 2
Joined: Thu Dec 31, 2020 9:30 pm

Just purchase my machine

Post by Spideryon » Thu Dec 31, 2020 9:40 pm

Hi, i just recieved the a20t from Amazon vendor few days ago and i having hard time dealing with stringing, i download stl file with 2 towers just for checking my cura settings and i having the impresion that the retraction settings doesnt change despite the settings i change... I am using last version of cura and my machine marlin version is 1.1.8, i believed this is too old so maybe cura software isnt working correctly because of this?

I would loves if someone could tell me the best settings to avoid stringing in cura, ir if i should try to update the firmware befeore...

Thank you for your time.

Post Reply