Hi,
I have a A20T Geeetech printer and am new to 3D printing.
This is a basic faceplate design that I made in Fusion 360, which initially had a font engraved in the control buttons, but that did not print as expected. I printed this flat, version v22
I printed it on a Raft, but the raft did not separate well, so it kinda chipped (Pic 1) the Font also did not come out as expected.
I then rotated it with the long side oriented X-Y and vertical and removed the lettering, this time I printed it in line with Bed movement (Y Axis), but it split into 2. Maybe no supports? Pic 2
Today, I tried printing it oriented X-Y (longer side along the extruder movement (X direction) and the thinner side on the Y direction (this was also vertical). I used the Raft in these cases too, but it separated easily. I used supports, but the holes turned out oblong partially on the print, with fine filament (Pic 3)
Could someone please point me in the right direction with what settings I can improve or the best direction for printing, I have looked through a number of settings but it looks very complicated.
I'm happy to share settings to help troubleshooting.
Many Thanks
/Earl
A20T - Help with settings
A20T - Help with settings
- Attachments
-
- Front Panel-SDR-2 v30.7z
- STL file
- (17.08 KiB) Downloaded 314 times
-
- Pic 2.jpg (224.37 KiB) Viewed 4338 times
-
- Pic 1.jpg (171.68 KiB) Viewed 4338 times
-
- Pic 3.jpg (284.3 KiB) Viewed 4338 times