Concerning noises during bed alignment??

Post Reply
AdamZampa
Posts: 1
Joined: Tue Nov 16, 2021 7:36 pm

Concerning noises during bed alignment??

Post by AdamZampa » Tue Nov 16, 2021 7:37 pm

Hello... I have a new A20M and powered it up for the first time a few days ago. During my attempt to adjust the bed(?) there were concerning noises a couple of times during the process. I am not a 3D printer guy, but one of the noises I think was due to some type of limit switch issue at the left-most front stop, the other was when in the center of travel it shook like crazy. I don't know what "normal" is as I am new to all this. Are there trouble-shooting manuals, etc. for this? I am reasonably technical but not with 3D printers. I don't want to proceed further until these issues are addressed assuming they are indeed issues.showbox speed test

Post Reply