Mixer

Post Reply
Mikey1209
Posts: 5
Joined: Tue Jul 20, 2021 7:55 pm

Mixer

Post by Mikey1209 » Sat Oct 02, 2021 6:46 am

Before I start the print I pre heat pla, auto home then check the Mix is the colour extruder I want ie 0% 100% or 100% 0% or 50% 50%.
However when I start the print it starts as 50% 50% the automatically after 10 or 20 seconds it reverts to 100% 0% and I have to change it to what I want after the print has started.
I have an A20M with gt2560 V4 and the latest firmware, No 3d touch.

Post Reply