printing stopped at 97 to 98 % before end of process

Post Reply
alfvv12
Posts: 29
Joined: Sun Jul 12, 2020 6:06 pm

printing stopped at 97 to 98 % before end of process

Post by alfvv12 » Sat Jul 17, 2021 6:08 pm

hi.

i use cura 4.9.1. and geeetech A20m.

the prints are stopped shortly befor the print is completed. mostly 97 to 98 finished.....

i found no solution...

any idea??

thx

User avatar
Admin
Posts: 486
Joined: Wed Nov 30, 2011 9:49 am

Re: printing stopped at 97 to 98 % before end of process

Post by Admin » Mon Jul 19, 2021 2:26 pm

Hello, are you printing a multi-color model? If so, the temperature of the extruder may be too low during the refueling process, causing cooling. You can increase the temperature to prevent printing failure.
Or the problem with the TF card, you can try to print online, or replace the Tf card.

runyon13
Posts: 1
Joined: Mon Aug 16, 2021 5:42 pm

Re: printing stopped at 97 to 98 % before end of process

Post by runyon13 » Mon Aug 16, 2021 5:45 pm

alfvv12 wrote:
Sat Jul 17, 2021 6:08 pm
hi.

i use cura 4.9.1. and geeetech A20m.

the prints are stopped shortly befor the print is completed. mostly 97 to 98 finished.....

i found no solution...

any idea??TelltheBell

thx
Since they have a thermal cutoff, your extruder will stop working in the middle of your print if the temperature gets too high. The only way to resolve this issue is to turn off the printer and allow the electronics to cool down. To avoid the problem completely try adding an extra cooling fan.

Post Reply