Geeetech A20 + BlTouch = first layer height question

Post Reply
chadcolen83
Posts: 3
Joined: Fri Jan 22, 2021 3:09 pm

Geeetech A20 + BlTouch = first layer height question

Post by chadcolen83 » Fri Aug 06, 2021 12:32 am

Hey,

i got an A20 from Geeetech and upgraded a BLTouch to it.
I followed the instructions to setting up the right nozzle height.
I adjusted the Z-Offset until a piece of paper (round about 0.1mm thick) is slightly
scratching on the nozzle when Z = 0mm. Therefore my nozzle is 0.1mm away from the
heatbed. Now im slicing a STL with 0.15mm first layer height. Accordingl10.0.0.0.1 192.168.1.254
y my nozzle now
should be 0.25mm away from the heatbed. Am i right?

My problem is, the first layer wont stick well enough on that height and my nozzle seems to just
lay down a line of PLA on my bed and pulling it around the heatbed.

Did i missing something? Do i need to adjust my z-offset, so my nozzle is touching my bed or do i
have to adjust my first layer height in Cura to near zero, so my nozzle is 0.1mm away from the bed
on the start of printing?

Greetings from Germany.

Post Reply