Need help with my geeetech a20

Post Reply
PacoBelan
Posts: 2
Joined: Thu Jun 10, 2021 4:46 pm

Need help with my geeetech a20

Post by PacoBelan » Thu Jun 10, 2021 4:48 pm

Hey guys, so I'm new to 3D printing. I've got my hands on a geeetech a20 and after assembling the printer with the help of an awful manual, it was almost ready. To level the printer, the manual told me to fasten all four feather screws that hold up the hotbed. After I did that, I turned the printer on and pressed "auto home". The printer automatically moved the nozzle to the bottom left nearside corner. But here's my problem: Since the Z axes is already down so much that the Z POS Sensor doesn't allow any further movement down, the nozzle is about 5-10mm above the hotbed. Does anyone know a fix for that? I think moving it up with the feather screws will mess up the evenness of the hotbed.

Thank's already!

Morgest
Posts: 12
Joined: Thu Oct 25, 2018 6:01 pm

Re: Need help with my geeetech a20

Post by Morgest » Wed Aug 11, 2021 1:47 am

If you want to learn the new languagea then its not that difficult to learn though as you can check the same here https://repairdaily.com/tips-how-to-hel ... -students/ useful site with professional support who can help you in each time as you check new problem

Post Reply