Geeetech

Hi,
Yes, it is. Please refer to the video: https://www.youtube.com/watch?v=fmwMq9t-Nxc&t=13s , and the picture below:

Hi,
I think you need to set the nozzle temperature to about 240 degrees, clean the hotend, then reload the filament.

Hi,
The voltage on the motherboard usually is 5V. This is our design.

Best regards

Hi,
Maybe you can try to turn to top screw like the picture attached, clockwise or counter-clockwise.

MOCCOR wrote: ↑

Mon Oct 11, 2021 5:50 am

Is there a guide about using PID autotune for the Geeetech printers anywhere?

Sorry! We don't have this guide.

Hi! How can I check where to drop right down to 40c for far superior adhesion? Can you share more insights you found out cause I am still having doubts... domyessay for printing geeetech design The super plate is a little thicker, so you maybe can try to lower the hotbed, or adjust the Z endstop mo...

Hello, it may be a wiring error. Please pay attention to the wiring of 3dtouch, and whether the 3pin and 2pin pins are correctly connected in place.
You can refer to the following video to install:
https://www.youtube.com/watch?v=IaHzsd4DgeU

Hello, you did not choose the correct COM, please refer to the link below to install the CH341 driver.
http://www.geeetech.com/forum/viewtopic ... 974#p81974

Hello, maybe it is the heating wire or the thermistor. Do you have a multimeter? You can measure the resistance of the thermistor and heating rod to see if it is around 90K ohms and 15 ohms.

Hello, you can contact the sales team of geeetech:
sales@geeetech.com
It is an old motherboard, if it is still in stock, they will provide you with it.