Search found 6 matches

by Neil PC
Mon Apr 12, 2021 7:32 pm
Forum: Print Quality
Topic: Where have I gone wrong?
Replies: 2
Views: 1414

Re: Where have I gone wrong?

Thank you, I will give it a go. I have persevered with it and got the quality as in the pictures, however i am now experiencing layer separation on the last 4 outer layers, but the rest of the print looks ok. I apologise for the delay in coming back to you you ;) I have just downloaded the Easyprint...
by Neil PC
Mon Mar 29, 2021 10:12 pm
Forum: Print Quality
Topic: Where have I gone wrong?
Replies: 2
Views: 1414

Where have I gone wrong?

Hi all
I have installed my first roll of filament and I cannot get a decent print
I have an A20T and bought some EONO filament from Amazon
I use cura slicer.
by Neil PC
Wed Mar 17, 2021 11:06 pm
Forum: Leveling Guide
Topic: G Code to enable bed level prior to print
Replies: 2
Views: 2541

G Code to enable bed level prior to print

Hi
I have finally got my BL Touch to work and I would like to enable an auto bed level prior to every print?

is there a code I can put into Repetier Host Start code to do this, and if so what is it please?

many thanks

Neil
by Neil PC
Thu Mar 04, 2021 1:54 am
Forum: A20T
Topic: BL Touch Install
Replies: 0
Views: 1057

BL Touch Install

After spending days trying to install the firmware 2.3 using Rapier Host and it failing every time I saw a post on here suggesting Cura. I tried that and it installed first time. I then experienced difficulties with setting up the Z offset and the probe failing and entering alarm mode, this could ha...
by Neil PC
Wed Feb 17, 2021 11:58 pm
Forum: A20T
Topic: BL 3d Touch Probe resetting
Replies: 0
Views: 869

BL 3d Touch Probe resetting

Hi I am a newbie to the forum and 3d Printing. I have just bought an A20T and a BL 3d touch probe, after going through the forum I managed to update Hex firmware using Cura. so i am now running Marlin: 1.1.8 HW Ver: GT2560 V4.1 FW Ver: 2.3 I have manually leveled the bed and installed BL Touch, howe...