Search found 6 matches
- Mon Apr 12, 2021 7:33 pm
- Forum: Leveling Guide
- Topic: G Code to enable bed level prior to print
- Replies: 2
- Views: 6200
- Mon Apr 12, 2021 7:32 pm
- Forum: Print Quality
- Topic: Where have I gone wrong?
- Replies: 2
- Views: 4237
Re: Where have I gone wrong?
Thank you, I will give it a go. I have persevered with it and got the quality as in the pictures, however i am now experiencing layer separation on the last 4 outer layers, but the rest of the print looks ok. I apologise for the delay in coming back to you you ;) I have just downloaded the Easyprint...
- Mon Mar 29, 2021 10:12 pm
- Forum: Print Quality
- Topic: Where have I gone wrong?
- Replies: 2
- Views: 4237
Where have I gone wrong?
Hi all
I have installed my first roll of filament and I cannot get a decent print
I have an A20T and bought some EONO filament from Amazon
I use cura slicer.
I have installed my first roll of filament and I cannot get a decent print
I have an A20T and bought some EONO filament from Amazon
I use cura slicer.
- Wed Mar 17, 2021 11:06 pm
- Forum: Leveling Guide
- Topic: G Code to enable bed level prior to print
- Replies: 2
- Views: 6200
G Code to enable bed level prior to print
Hi
I have finally got my BL Touch to work and I would like to enable an auto bed level prior to every print?
is there a code I can put into Repetier Host Start code to do this, and if so what is it please?
many thanks
Neil
I have finally got my BL Touch to work and I would like to enable an auto bed level prior to every print?
is there a code I can put into Repetier Host Start code to do this, and if so what is it please?
many thanks
Neil
- Thu Mar 04, 2021 1:54 am
- Forum: A20T
- Topic: BL Touch Install
- Replies: 0
- Views: 2620
BL Touch Install
After spending days trying to install the firmware 2.3 using Rapier Host and it failing every time I saw a post on here suggesting Cura. I tried that and it installed first time. I then experienced difficulties with setting up the Z offset and the probe failing and entering alarm mode, this could ha...
- Wed Feb 17, 2021 11:58 pm
- Forum: A20T
- Topic: BL 3d Touch Probe resetting
- Replies: 0
- Views: 2359
BL 3d Touch Probe resetting
Hi I am a newbie to the forum and 3d Printing. I have just bought an A20T and a BL 3d touch probe, after going through the forum I managed to update Hex firmware using Cura. so i am now running Marlin: 1.1.8 HW Ver: GT2560 V4.1 FW Ver: 2.3 I have manually leveled the bed and installed BL Touch, howe...