Geeetech

kokko3d wrote: ↑

Wed Aug 25, 2021 1:22 pm

This is the problem for me... When I change on the screen and then I measure the first is ok and the other 2 are almost 3 times longer... So.. must be something wrong...

What firmware do you have? I have A30T-V1.02.03. I have a control board SMARTTO

Are you talking about the A30T.. Because I don't think it works for it.. I have done that for all my other printers.. But for this there is not custom firmware yet.. Yes.. there is marlin ready for it.. but you can't use it because there is not the right firmware for the screen... What I'm not unde...

Hello everyone. The problem I have is that the extruders are extruding at different lengths. The first one extrudes 106mm, and the second and third 100mm. How to fix it? If you change the value, it changes for everyone and then the first one throws out 100mm, and the steel 94mm. Buy new extruders t...

Hello everyone. The problem I have is that the extruders are extruding at different lengths. The first one extrudes 106mm, and the second and third 100mm. How to fix it? If you change the value, it changes for everyone and then the first one throws out 100mm, and the steel 94mm.

I decided to measure the extrusion distance and when measured on the second extruder, it extruded 93mm. I changed the settings, but now the problem is that the first extruder extrudes 106mm, and the second and third as expected 100mm. Why the distance is different is not clear. Now I'm thinking how ...

Also squeezed out 93mm. I changed the settings, but the problem is that the first extruder extrudes 105mm, and the second and third as expected 100mm. Now I'm thinking how to change the settings only for the first one. Or you will have to set the flow for the first extruder less. Or does the support...

downloading the program https://www.geeetech.com/download.html?version_id=483 download firmware https://www.geeetech.com/download.html?version_id=474 connect your computer (laptop) to the printer in the downloaded archive with the program, run the file main.exe at the top left, select the com port d...

If you look at the picture, then you have the wrong firmware

I configured myself like this 1 autolevel disable 2 lower the table to the very bottom 3 through the menu, slowly lower the extruder until the Z axis sensors are triggered 4 we raise to the smallest size that can be set on the display (if I remember correctly, then like 0.1 mm), so that the Z sensor...