Geeetech

Please can you take a look of my EasyPrint3D Settings ? I will know that the settings perfect!

thank you

Hello! The Tube is okay (clear and well formed). Please can you take a look of my EasyPrint3D Settings ? I will know that the settings perfect! btw: Firmware-Updates: The next fault on this Printer is the different display of FW-Version. EasyPrint3D tells a other FW-Version as i can see on the LCD I...

Damn... my first reply was lost in this forum... okay again: my settings : see the attachments. Can you identify any problems equal to my problems ? 1.Heating the temp of nozzle up to 210C 2.Remove the Teflon cube and then clean it with the ejector 3.Check the retraction distance/speed of your setti...

No - it doesn´t help!

"The Printer is not connected" - but the printer IS connected. While starting Cura the E180 restarts (ergo: Communication is etablished)
in the how-to there is no information about which type of printer is set.

Hello! Thanky for your reply! The Settings (see attached Pictures) 1. Heating is anytime 210C - The EasyPrint can set it coincidentally to 175C and then i can emergency stop :( 2. Remove the Teflon Cube - What is that ? 3. The retraction speed is an mystery: the gear on the filament-Input (i don´t k...

Hey - i´m new in betatesting the E180 ;) my main-problem is: while printing after a unspecific time the extruder stucks and not enough filament came to the nozzle -> Printing impossible -> bad printing -> Out for Trashcan. On the next printing there is again the same problem or even not! ... this "f...

Hello! What means the Photos ? can you MORE specific tell what theay means ? (e.g. E180-Swap.jpg) means that the A4988 must be changed with any other ? Wich one you mean ? Swap the top with the right or ? Please explaine if you want to help - thank you! BTW: what does the nozzle in this case of extr...