Geeetech

I replaced mine with an IRL8743 and its running very cool.

I also soldered the 12V supply directly to the board as when the mosfet was faulty, it melted the 4 pin power connector.

Having the same problem.

Can the Mosfet be replaced (will this fix the problem)?

More than happy to test for you.
Regards
Alan

Let me know if you need someone in Australia.
Regards
Alan

I had similar issues. In fact the L shaped extruder arm was cracked. Replaced with the aluminium replacement (about $US8) and haven't looked back since. Only issue is that the aluminium kit is slightly wider than the plastic one, so the screws were slightly too short. I counterbored the holes in the...

I had similar issue with plastic pressure arm - placed packing under spring which worked for a while, then had all sorts of problems with poor extrusion. The L shaped pressure arm turned out to be cracked, so replaced it with the aluminium replacement and has been working perfectly since. The only i...

Had exactly the same problem and fixed it today with 2mm packing. Now works fine. Wish I'd seen this post two weeks ago!

I connected a filament cooling fan to the PWN socket.
You just need to switch the fan on in Repetier.
Cura & Slic3er have settings so it won't go on until you reach a specified level (first layers adhere better to the bed without cooling fan).

Yes, the LCD comes on only if USB cable is plugged in, but none of the functions work (e.g.Auto home, shift axis). I have attached link to two photos - one shows PSU switched on, but green LED on PSU not lit. The other shows multimeter reading of 154mV on the output of the PSU (connector removed fro...

Unable yo upload firmware as computer does not connect to printer.

I checked the output of the PSU (with the cable to the main board unplugged) and it is less than 1V.
Light on PSU does not light, nor the LCD and the fans are not working.
I suspect PSU is faulty.

Alan