Problem reading temperature Rambo Board

User avatar
techsupport
Site Admin
Posts: 210
Joined: Sat Mar 03, 2012 2:32 pm

Re: Problem reading temperature Rambo Board

Post by techsupport » Thu Jul 03, 2014 6:14 pm

you can test the r32 r37 r28 r39 is solded well。the min temp err means that the thermistors is not connected well with mega2560.it is open circuit。
Your real trustworthy partner in China!!
Email: forum@geeetech.com

daxer70
Posts: 17
Joined: Tue Jun 24, 2014 1:21 pm

Re: Problem reading temperature Rambo Board

Post by daxer70 » Fri Jul 04, 2014 1:17 am

I'm not expert in dmd soldering, I've only tested all the resistors with the multimeter and always got around 4.3 k value

User avatar
techsupport
Site Admin
Posts: 210
Joined: Sat Mar 03, 2012 2:32 pm

Re: Problem reading temperature Rambo Board

Post by techsupport » Fri Jul 04, 2014 3:37 pm

Please see the attached figure,You provide resistance value is normal,
You can check the electronic circuit is normal? waiting your reply.
Best regards
Attachments
Rambo-T0.T1.rar
(9.56 KiB) Downloaded 536 times
Your real trustworthy partner in China!!
Email: forum@geeetech.com

daxer70
Posts: 17
Joined: Tue Jun 24, 2014 1:21 pm

Re: Problem reading temperature Rambo Board

Post by daxer70 » Sat Jul 05, 2014 1:46 am

To much complicated for me…

between T0 pins I have around 9 k ohm, the same on T1

cannot test further

Post Reply