Damaged/faulty Sanguino board

Post Reply
matthewbartlett
Posts: 1
Joined: Fri Aug 23, 2019 5:00 pm

Damaged/faulty Sanguino board

Post by matthewbartlett » Fri Aug 23, 2019 5:02 pm

Hi, I bought 2 Sanguino boards from Seller:tenovo2010 on ebay which were meant to be fully assembled and tested.
One of them worked fine the other was damaged, the mosfet for the heated bed was bent and the legs were damaged and the chip would not communicate with any programmer (I tried AVRISP II, ATmel dragon and USB tiny). I suspect it was damaged during shipping and the same impact that damaged the mosfet broke the chip. The seller asked me to write post on this forum before they would help me, any advice?

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Damaged/faulty Sanguino board

Post by William » Fri Aug 23, 2019 5:54 pm

Hi, Can you provide a specific picture?
If it is not working properly, you can contact your sales to replace it.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply