Bltouch position settings

Post Reply
Shinobi
Posts: 12
Joined: Tue Jan 01, 2019 10:00 pm

Bltouch position settings

Post by Shinobi » Wed Nov 13, 2019 3:14 am

Hi,

normally the Bltouch is to the left of the hotend, but i switched to an E3D V6 and now my Bltouch is to the right and a bit in front of the hotend. Where can I set the parameters to change the position, so that the mesh bed leveling finds the correct spots again?

Thanks a lot!


Best regards

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Bltouch position settings

Post by William » Wed Nov 13, 2019 9:21 am

:D Hi, you can provide a specific video
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Shinobi
Posts: 12
Joined: Tue Jan 01, 2019 10:00 pm

Re: Bltouch position settings

Post by Shinobi » Thu Nov 14, 2019 5:10 pm

vert wrote:
Wed Nov 13, 2019 9:57 am
you need to measure and adjust the probe offset in marlin recompile and flash to change this.
ok I've dont that and changed it via the M851 command. It seems good now, but the bed leveling now is in the wrong places. Is it possible that the x,y offset are hardcoded in the routine?

Post Reply