I load STL file.. launch Slicing and from a regular 3d i obtain the same model but with some "extra lines" (incorrect slices) added to the original.
So if i print it, the printed model results in a wrong model. It does not happens with EVERY models, but 8 on 10. I thinked to find a slicer software to generate gcode and print using it. But EasyPrint3d uses Cura that is a good slicing program.. why it fails? No errors, no warnings.. but the sliced model is wrong. Can you help me ?
Thanks in advance and sorry for the poor english.
Thanks for your help.
The starting gcode (its too big for posting)
Code: Select all
;FLAVOR:RepRap ;TIME:6666 ;Filament used: 0m ;Layer height: 0.1 ;Generated with Cura_SteamEngine master M190 S50 M104 S200 M109 S200 G28 ;Home G1 Z15.0 F6000 ;Move the platform down 15mm ;Prime the extruder G92 E0 G1 F200 E3 G92 E0 ;LAYER_COUNT:2036 ;LAYER:0 M107 G0 F3600 X95.994 Y123.492 Z0.2 G0 X96.509 Y123.122 ;TYPE:SKIRT G1 F1800 X96.589 Y123.075 E0.00772 G1 X100.717 Y121.146 E0.38659 G1 X103.217 Y119.87 E0.61997 G1 X108.108 Y117.104 E1.08719 G1 X112.849 Y114.058 E1.55576 G1 X115.155 Y112.435 E1.79023 G1 X118.648 Y109.786 E2.15475 G1 X118.755 Y109.724 E2.16504 G1 X118.986 Y109.626 E2.1859 G1 X119.181 Y109.586 E2.20245 G1 X119.318 Y109.605 E2.21395 G1 X119.628 Y109.693 E2.24075 G1 X119.842 Y109.818 E2.26136
- IMG_7474.jpg (485.68 KiB) Viewed 10411 times
- IMG_7473.jpg (479.43 KiB) Viewed 10411 times
- IMG_7472.jpg (425.01 KiB) Viewed 10411 times
- IMG_7471.jpg (560.6 KiB) Viewed 10411 times
I think the "extra line" you said is a "support" for your model.
The "support" is used to support suspended parts of model. You need to flip the owl to a right direction.(Do not leave most of the models suspended）
Who is online
Users browsing this forum: No registered users and 4 guests